Manual Controlled Hydro Test Bench

This test bench can perform Hydrostatic test, Burst test,Leak test,Proof pressure test on the following items: Automobile steering tube, brake pipe, air-conditioning pipe, oil pipe, water pipe cooling, radiator, heater hose, hydraulic equipment, condenser, evaporator, air conditioning filter hose, turbocharging system hose, car brake pump, cylinder body, project hydraulic hose, air hose and manifold, rigid pipe, joints, valves, cylinder, pressure gauges, pressure sensor, pressure vessel, pressure transmitter, etc.

Working Principle

The test bench uses compressed air as power source, converts the 3-8 bar compressed air into higher hydraulic pressure through pneumatic liquid booster pump, and then uses the hydraulic pressure as the test medium to carry out hydro-static testing & burst testing on various items.

Features

1.Testing medium: Water or Oil (using air as test medium needs to be customized)

2.Applicable to hydrostatic testing & burst testing & leak testing for various items 

3.Wide outlet pressure range 32 - 4080 bar for your choice

4.Outlet pressure can be fine regulated

5.Equipped with protective test chamber to ensure staff safety

6.Automatic pressure maintenance during testing process, when the pressure drops, the system will automatically replenish pressure

Models & Parameters

Remark:

(1).The flow rate above is the flow rate output by built-in hydraulic booster pump.

(2).There is an electric water injection pump built in the test bench ( flow rate 30L-100L/Min). 

(3).To speed up the testing progress, firstly you could activate the electric pump to fill normal flowing water into testing item, then activate the hydraulic booster pump to generate high pressure liquid and inject it into the test item.

Operational Steps

(1). Fill water or hydraulic oil into the liquid tank.

(2). Put testing object inside the cabinet and connect it onto High-pressure outlet with a hose, then close the cabinet 

(3). Connect air compressor onto the Driven-air inlet port

(4). Turn off Unloading valve and turn on High pressure liquid outlet valve, then adjust driving air pressure by Driven air regulator to preset testing pressure value.

(5). Turn on Driven air switch, the machine starts running and generates high hydraulic pressure which is used to make hydrostatic test or burst test for the testing object.

(6). After the hydraulic test is completed, turn off the Drive air switch firstly, then turn on Unloading valve to let the high pressure liquid return to the liquid tank, and finally remove the testing object from the machine.